28
DXP HD 4K Series • Operation
Selecting the Remote RS-232 Port Baud Rate
NOTES:
•
The serial port baud rate setting is protected when front
panel lock mode 2 is selected. You can view the setting in
lock mode 2 but you cannot change it from the front panel.
•
To enable changes to the baud rate setting, set the lock
mode to
0
.
To set the baud rate from the front panel:
1.
Simultaneously press and
hold
all
Control buttons (
Enter
,
Preset
,
View
[DXP 168 and 1616 only] and
Esc
) until all of the
Control buttons or their LEDs light, as well as input buttons 1
and 2 (approximately 2 seconds).
2.
Press the appropriate Control button to select the baud rate.
The selected Control button or its LED blinks.
•
Enter
= 9600
•
Preset
= 19200
•
View
= 38400 (DXP 168 and 1616 only)
•
Esc
= 115200
Figure 24.
RS-232 Baud Rate Display
3.
Release the Control buttons.
4.
Press and release an output button to exit the Serial Port
Configuration mode.
