DXP HD 4K Series • Operation
42
DXP 1616 Series — Muting and Unmuting Outputs
1.
Press and release the
Esc
>
button.
C O N T R O L
PRESET
ENTER
ESC
VIEW
Press the
Esc
button to clear all selections.
The button blinks once.
Figure 66.
Clearing All Selections
2.
Press and release the
View
<
button to enter view-only mode. The
View
<
button
lights green.
All untied output buttons light.
Press the
View
<
button
to enter view-only mode.
The
View
<
button lights green.
VIEW
Figure 67.
Entering View-only Mode
3.
To select both video and audio for viewing and muting, if necessary, press and release
the
Video
and
Audio
buttons.
I / O
3
8
9 10 11 12
14 15 16
13
INPUTS
4
2
1
NOTE:
Until you select an input, the buttons for
outputs 1 through 4
light
amber
if no
inputs are tied,
green
if no video inputs are tied (only audio is tied), or
red
if no audio
inputs are tied (only video is tied).
Outputs 5 through 16
light
green
if no video inputs are tied (because audio is not
supported on these outputs, they do not light red or amber).
AUDIO
VIDEO
Press the
Audio
button to
toggle audio on and off.
The button lights red when
selected.
Press the
Video
button to
toggle video on and off.
The button lights green
when selected.
OUTPUTS
5
5
6
7
1
4
2
3
6
7
8
9 10 11 12 13 14 15 16
Figure 68.
Selecting Video and Audio for Viewing and Muting
NOTE:
Output mutes are protected when front panel lock mode 2 is selected. You
can view the mutes in lock mode 2 but you cannot change them from the front
panel (see
Locking and Unlocking the Front Panel (Executive Modes)
page 45).
If front panel lock mode 2 is selected and you try to perform steps 4 and 5, the
actions are ignored. Set the lock mode to
0
to enable changes.