DVS 510 Series • Operation
35
Figure 22 shows the
Edit
Comm
Settings
screens and the adjustments that are available
from them.
Next
Serial Config
9600 RS232
Next
Set DHCP Mode
Off
Next
Set the DHCP mode:
•
Off (Default)
•
On
Set IP Address
192.168.254.254
Next
Next
Edit Comm
Settings
Press and hold
Next + [Color/Tint].
Select the baud rate:
•
9600 (Default)
•
19200
•
38400
•
115200
Select the serial
communication type:
•
RS232
•
RS422
Next
Select an octet.
Increase or decrease
selected number:
•
Range: 000 through 255
(each octet)
•
Default: 192.168.254.254
Set the IP Address:
Set Gateway Addr
000.000.000.000
Select an octet.
Increase or decrease the
selected number:
•
Range: 000 through 255
(each octet)
•
Default: 000.000.000.000
Set the Gateway Address:
Set Subnet Mask
255.255.000.000
Select an octet.
Increase or decrease the
selected number:
•
Range: 000 through 255
(each octet)
•
Default: 255.255.000.000
Set the Subnet Mask:
2 Sec.
Figure 22.
Edit Comm Settings Menu
Adjustments can be made via the following
Edit
Comm
Settings
screens:
Serial Configuration submenu
1.
Press
NEXT
until the
Serial
Configuration
screen is displayed.
2.
Rotate the horizontal
ADJUST
knob (
[
) to select the baud rate. The available
selections are
9600
(the default),
19200
,
38400
, and
115200
.
Rotate the vertical
ADJUST
knob (
{
) to select
RS232
or
RS422
.
Set DHCP Mode submenu
When Dynamic Host Configuration Protocol (DHCP) mode is enabled, the scaler ignores any
entered IP address and obtains its IP address from a DHCP server (if the network is DHCP
capable).
On the
Set
DHCP
Mode
screen, rotate either
ADJUST
knob to the right to turn DHCP on or
to the left to turn DHCP off. Contact your system administrator for the setting to select.
