DTP2 T 202 FB • Installation and Operation
19
Switch Modes
The switching transmitter has three switch modes:
•
Manual
— The input must be selected manually using an SIS command
•
Auto switch (DisplayPort)
— The switcher automatically selects the input with an
active signal present and, if both are present, prioritizes the DisplayPort input. This is the
factory default mode.
•
Auto switch (HDMI)
— The switcher automatically selects the input with an active
signal present and, if both are present, prioritizes the HDMI input.
These modes can be selected through SIS commands (see
on page 22) or the Product Configuration Software (see the PCS Help file).
EDID
To manage EDID on the DTP2 T 202 FB, use the Product Configuration Software (see
Product Configuration Software Help file).
Reset Mode
Use the recessed
Reset
button on the top panel of the transmitter (see
on
page 11) to initiate two levels of reset as follows:
Reset to factory default condition
— Cycle unit power off and on while
holding
the
Reset
button. All top panel LEDs cycle. Release the button.
Reset to default settings
— Press and
hold
the reset button for approximately 6
seconds. All top panel LEDs cycle. Release the button. This reset is the equivalent of issuing
the
E
ZXXX
}
, see page 25).
Troubleshooting — If no Image Appears
1.
Ensure that all devices are plugged in and powered on. The switcher is receiving power
if one of the input LEDs is lit.
2.
Ensure an active input is selected on the switcher or that the switcher is in auto-input
switching mode.
3.
Ensure that the proper signal format is supplied.
4.
Check the cabling and make corrections as necessary.
5.
Call the Extron S3 Sales & Technical Support Hotline if necessary (see
for the phone number in your region of the world).
Summary of Contents for DTP2 T 202 FB
Page 6: ......
