Extron electronics DTP2 T 202 FB, User Manual

Page: 16 / 40

DTP2 T 202 FB • Installation and Operation 8
A
Power connector (see figure 7 on the previous page) — Plug the included
+ -
1.4A MAX
12V
POWER
external 12 VDC power supply into this 2-pole connector (see Power supply
wiring on page 14 to wire the connector).
— or —
Supply power to the receiver (see the appropriate user guide, available at
www.extron.com ) and leave the switches as described in the NOTES below.
ATTENTION:
• The DTP2 device is configured to output power to DTP2 models only.
If connected to a legacy DTP device, set the
Send Power toggle switch
( item
E
on page 9) to the Off position (right). Failure to turn the power off
will damage the connected legacy DTP device.
• L’appareil DTP2 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S’il est connecté à un modèle DTP traditionnel, veuillez
positionner l’interrupteur à bascule
Send Power
(
E
) sur « Off » (droite).
Si l’interrupteur n’est pas positionné sur off, vous risquez d’entraîner la
défaillance de l’appareil DTP connecté.
NOTES:
• When the following switches are set as follows , one power supply can
power both units:
• Send Power switch ( item
E
) is in the Send position.
•
TP
function switch ( item
F
) is in the
DTP2
position.
• When either switch is not as described , the transmitter and receiver each
require a local 12 VDC power supply.
B
Remote RS-232 port — Plug a host device into the switching transmitter via
Tx Rx G
RS-232
REMOTE
the 3.5 mm, 3-pole captive screw connector for remote control of the
transmitter (see
Serial and IR port connectors on page 16 to wire the
connector).
•
9600 Baud • 8 data bits
• No parity • 1 stop bit
C
Over TP RS-232 and IR port — Plug a serial RS-232 signal, a
IR RS-232
Rx Rx G Tx Tx
OVER TP
modulated IR signal (up to 40 kHz), or both into this 3.5 mm, 5-pole direct
insertion connector for bidirectional RS-232 and IR communication (see
Serial and IR port connectors to wire the connector). RS-232 and IR
data can be transmitted simultaneously.