DTP T HWP 4K D Series • Setup Guide
This setup guide provides instructions for an experienced installer to set up and operate the Extron DTP HWP 4K 231 D and
DTP HWP 4K 331 D HDMI extenders.
Installation
Step 1 — Prepare the Mounting Surface
NOTE:
Use a wall box with a depth of at least 3.0 inches
(7.6 cm). Alternatively, the included mud ring (MR 100)
can be used.
For more information, see the full product user guide at
www.extron.com
. The installation must comply with the
National Electrical Code and all applicable local codes.
a.
Place the wall box against the installation surface and mark the
opening guidelines.
b.
Cut out the material from the marked area.
c.
Secure the wall box with 10-penny nails or #8 or #10 screws,
leaving the front edge flush with the surface.
d.
Run all required cables (see steps 4, 5, and 6) and secure them with cable clamps.
TIP:
To ensure a proper fit the unit in the junction box, do not
install boots on TP cables and RJ-45 connectors.
Step 2 — Disconnect Power
Disconnect all equipment from power sources.
Step 3 — Connect Inputs to the Transmitter
A
HDMI input connector
— Connect an HDMI cable between this port and the output port of the digital video source.
B
Audio input
— Connect an unbalanced stereo audio source to this 3.5 mm mini stereo jack.
NOTE:
The units do NOT embed analog audio onto the HDMI signal. This analog audio signal is
transmitted simultaneously with audio embedded within the HDMI signal.
Wall Stud
Screws
or Nails
Signal
Output
Cable
HDM
I IN
AU
DIO
IN
Decorator-Style Faceplate
Extron
DTP T HWP 4K D Series
Extender
HDMI IN
AUDIO IN
E
Tx
Rx
Tx
Rx
RS-232
IR
G
HDBT
DTP
O
VER
TP
OUT
PO
WE
R
12V
0.7A MAX
DTP T HWP 4K D Series
Front Panel
DTP T HWP 4K D Series
Rear Panel
A
F
B
C
D
E
A
HDMI Input Connector
B
Audio Input Connector
C
Over TP RS-232/IR Connector
D
HDBaseT/DTP Mode Switch
E
TP Out Connector
F
Power Connector