Extron electronics DTP HD DA 4K Series, User Manual, Page: 15 / 42

Extron DTP HD DA 4K Series • Installation and Operation 7
Connection Details
For connectors that require additional wiring details or recommendations, see the following
sections pertaining to the type or connection.
TP Cable Recommendations and Termination for DTP Communication
Use the following configuration for twisted pair cables used for DTP communication.
5
Pin
1
2
3
6
7
8
4
Side
12345678
Insert
Twisted
Pair Wires
Pins:
RJ-45
Connector
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
TIA/EIA T
568 B
Figure 6. RJ‑45 Pin Assignment for DTP Communication
Supported cables
The distribution amplifiers are compatible with shielded twisted pair cable (F/UTP, SF/UTP,
and S/FTP).
ATTENTION
:
• Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the device with DTP transmitters or receivers.
• N’utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d’Extron ou
le câble STP201 pour relier le appareil avec les émetteurs ou les récepteurs DTP.
Cable recommendations
Extron recommends using the following practices to achieve full transmission distances up
to 330 feet (100 meters) and reduce transmission errors.
• Use the following Extron XTP DTP 24 STP cables and DTP 24 connectors for the best
performance:
• XTP DTP 24/1000 Non-Plenum 1000 feet (305 meters) spool
•
XTP DTP 24P/1000 Plenum 1000 feet (305 meters) spool
• XTP DTP 24 Plug Package of 10
• If not using XTP DTP 24 cable, at a minimum, Extron recommends 24 AWG, solid
conductor, STP cable with a minimum bandwidth of 400 MHz.
• Terminate cables with shielded connectors to the TIA/EIA-T568B standard.
•
Limit the use of more than two pass-through points, which may include patch points,
punch down connectors, couplers, and power injectors. If these pass-through points
are required, use shielded couplers and punch down connectors.
TP Cable Recommendations and Termination for DTP Communication
6