Power Save Mode
In power save (standby) mode, all non-essential hardware is shut down in order to
conserve power.
•
To enable power save mode, enter the
Power
Save
On
SIS command (see the
on page 54).
•
To exit power save mode, either enter the Power Save Off SIS command or press any
front panel button. If the front panel is locked, this method does not work.
NOTE:
The backup and restore functions available through the PCS control software
are not accessible while the unit is in power save mode.
Presets
A preset is a set of input parameters that are either saved by you or automatically by
the DSC as a files in DSC memory. Saved presets can be recalled and their settings
implemented at any time. A preset saves time by enabling you to apply a group of settings
to the DSC at one time.
The DSCs have three types of presets: Auto Memories, user presets, and global input
presets.
Auto Memories
The DSC has 32 memory locations in which the current input configuration and picture
control values are automatically stored as an input preset, when Auto Memory is enabled.
An Auto Memory preset is recalled when an identical input resolution and rate is applied to
the input.
Each Auto Memory preset is stored with a time stamp that is incremented each time its
stored rate is detected. If all Auto Memory slots are occupied and a new rate is applied,
the Auto Memory with the oldest time stamp is overwritten.
Auto memory can be enabled using the OSD (see the
of the
Advanced
submenu on page 32) and by SIS commands (see the
commands on page 52).
The following information is stored in an Auto Memory preset:
•
Contrast
•
Active lines (Vertical Active)
•
Brightness
•
Horizontal image position
•
Detail
•
Vertical image position
•
Horizontal start
•
Horizontal image size (width)
•
Vertical start
•
Vertical image size (height)
•
Active pixels (Horizontal Active)
•
Total pixels
DSC 3G-HD A and DSC HD-3G A • Operation
37