Extron electronics DSC 3G-HD A, User Manual

Page: 55 / 75

X5( X5(
= Audio input type — DSC HD-3G A
0 = None: input is muted.
1
= Analog (on 5-pole captive screw connector)
2
= LPCM two-channel digital (embedded in the HDMI input) (default). LPCM-2CH audio is
requested from the source via EDID.
3 = Multi-channel digital (via EDID). Allows any digital audio format from the source.
Audio delay is applied and the signal is re-embedded into the HDMI output.
4
= (Unsupported input audio format)
X6) X6)
= EDID file data block, 128 or 256 bytes of binary data (machine-readable only).
X6! X6!
= Video signal status
0
= Video (DSC 3G-HD A) or TMDS (DSC HD-3G A) signal not detected
1
= Video or TMDS signal detected.
X6@ X6@
= Power save mode
0
= Full power mode (default)
1 = Low power mode
X6# X6#
= Screen saver status
0 = Active input detected, timer not running
1
= No active input detected, timer running, output sync active
2
= No active input detected, timer expired, output sync disabled
X6$ X6$
= Input lock (AFL) — DSC 3G-HD A only
0
= Disable input lock. Free running pixel clock is generated internally. (Default)
1 = Enable input lock. Locks output vertical to vertical refresh rate of the selected input.
X6% X6%
= Input lock (AFL) status — DSC 3G-HD A only
0 = Input lock (AFL) is disabled.
1 = Input lock (AFL) is enabled, but cannot lock to applied input signal. The DSC 3G-HD A
defaults to the set output rate.
2
= Input lock (AFL) is enabled. The output is locked to the applied input signal (AFL).
X6^ X6^
= Input lock (AFL) / SDI genlock — DSC HD-3G A only
0
= Disable input lock/genlock. Free running pixel clock is generated internally. (Default)
1 = Enable input lock (AFL). Locks the output vertical to the vertical refresh rate of the
selected input.
2
= Enable SDI genlock. Locks output vertical to selected genlock input.
X6& X6&
= Input lock (AFL) / genlock status — DSC HD-3G A only
0
= Input lock (AFL) / SDI genlock is disabled.
1
= Input lock (AFL) is enabled, but cannot lock to the applied input signal. The
DSC 3G-HD A defaults to the set output rate.
2 = Input lock (AFL) /SDI genlock is enabled. The output is locked to the applied input
signal (AFL).
DSC 3G-HD A and DSC HD-3G A • Remote Configuration and Control 47