2-13
TLP 350CV • Installation and Operation
1
2
Using the ZipClip 100
Attaching/removing the clip and power supply
To
attach
the power supply to the ZipClip 100 mounting clip:
1.
Insert the bottom of the power supply down into the clip, starting with one
end.
2.
Pivot the other end down and press until the clip snaps into place.
To
remove
the power supply from the ZipClip:
1.
Press the ZipClip tab.
2.
Pivot the power supply and lift it
out of the ZipClip.
Using tie wraps for cable strain relief
1.
Attach the power supply to the ZipClip 100 mounting clip.
2.
Fastening the power output cord to the ZipClip base.
a.
Insert tie wraps along the notches on the side of the power supply and
through the ZipClip tie wrap anchor points, then around the cord.
b.
Pull the tie wrap until secure. Do not over tighten.
Cable
Strain
Relief
Figure 2-12 — Insert tie wraps