Figure 14: SSA Switch Ground Receptacle
1 = Ground receptacle
2 Remove the pluggable transceiver from the anti-static packaging.
If there is a protective dust cover on the pluggable transceiver, do not remove it at this time.
Installing a Pluggable Transceiver
To install an SFP or SFP+ pluggable transceiver in your SSA switch, follow these steps:
1 Hold the pluggable transceiver so that the connector will seat properly.
2 Carefully align the pluggable transceiver with the port.
3 Push the pluggable transceiver into the port until the pluggable transceiver clicks and locks into
place.
Removing a Pluggable Transceiver
Caution
Do NOT remove an SFP or SFP+ pluggable transceiver from a slot without releasing the
locking tab located under the front bottom end of the transceiver. This can damage the
transceiver.
The transceiver and the SSA switch are sensitive to static discharges. Use an antistatic wrist
strap and observe all static precautions during this procedure. Failure to do so could result in
damage to the transceiver and the SSA switch. Always leave the transceiver in the antistatic
bag or an equivalent antistatic container when it is not installed.
Precaución: NO quite el SFP o SFP+ de la ranura sin antes abrir la traba ubicada en la parte
frontal del el SFP o SFP+.
Utilice la pulsera antiestática y tome todas las precauciones necesarias durante este
procedimiento. Si no lo hace, podrìa dañar el SFP, SFP+ o el SSA. Mientras no esté instalado,
mantenga el SFP o SFP+ en su bolsa antiestática o en cualquier otro recipiente antiestático.
To remove a pluggable transceiver from a port on your SSA switch, follow these steps:
Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
29
