4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 27
Positioning the device in the rack
1.
Screws, 10-32 x 5/8-in., panhead Phillips
2.
Retainer nuts, 10-32
Attaching the rear brackets to the extensions at the front of the device
Complete the following steps to attach the rear brackets to the extensions. There are short and long front brackets that you can use for
this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension.
The short rear brackets are shown in
. Use the first and third vertical pairs of holes for the screws.
Refer to
for the positioning of the short or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
Installing the Universal Four-Post Rack Kit (XEN-R000296)
ExtremeSwitching SLX 9540 Hardware Installation Guide
50
9036360-00 Rev AB
Summary of Contents for ExtremeSwitching SLX 9540
