Figure 23: WS-AO-DT05120 and Related Antenna Models
Table 14: Antenna Cable and Connector Information
Antenna Model
Cable Type
Cable Length
Connector Type
WS-AO-DT05120
RG316
32 inches
Reverse Polarity, Type N Jack
WS-AO-DT05120-1
RG316
32 inches
Reverse Polarity, Type N Plug
WS-AO-DT05120N
RG316
32 inches
Standard Polarity, Type N Plug
WS-AI-DT05120
RG316
32 inches
Reverse Polarity SMA Plug
Wave 2 Antennas
For specific information on antennas that support the AP3805e and information on each AP39XX series
antenna, refer to
Cable Installation Guidelines
The cable configuration that you use to connect an AP to an antenna varies. Use the following sections
as guidelines for cabling your AP to an antenna.
Do not install the cable in tight positions, as bending or applying excessive force to the connectors may
damage the antenna cable. Always allow the cable to bend naturally around corners.
The low-loss antenna cable must be secured along its complete length. Do not allow any part of the
cable to hang free. This is particularly important for cable parts that are installed outdoors. The antenna
cables and cable connectors are not designed to withstand excessive force:
•
Do not use connectors as cable grips to pull cable through raceways or conduits.
•
Do not use cable connectors to support the weight of the cable during or after installation.
•
Do not use tools to tighten connectors (finger-tighten only).
Antenna Installation
ExtremeWireless™ External Antenna with Wave 2
39