Extreme Networks EN-SLX-9030-48S-4C, Hardware Installation Manual

Page: 87 / 114

• The airflow direction of the power supply must match that of the installed fan assemblies. All must be either exhaust or intake.
NOTE
Power supplies are hot-swappable. However, they should be inserted or removed without a power cord being connected to a
power source to avoid damage.
CAUTION
Ensure that the airflow direction of the power supply unit matches that of the installed fan tray. The power supplies and fan
trays are clearly labeled with either a green arrow with an "E", or an orange arrow with an "I."
Inserting a new AC power supply
Use the following steps to install an AC power supply in the SLX 9030 device.
FIGURE 43 Installing an AC power supply unit
1. Power supply slot 2. Release lever
1. If replacing a power supply, remove the previously installed power supply from the appropriate slot by pressing the release lever
and pulling the power supply handle.
2. If installing a new power supply into a slot covered with a filler panel:
• 1. Press the release lever on the filler panel.
2. Remove the filler panel.
3. Before opening the package that contains the power supply, touch the bag to the switch casing to discharge any potential static
electricity. Extreme recommends using an ESD wrist strap during installation.
4. Remove the power supply from the anti-static shielded bag.
5. Holding the power supply level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring
that it firmly engages with the connector and the release lever clicks into its locked position.
Inserting a new AC power supply
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD 87