CANTILEVER
INSTRUCTIONS
3.5m x 3.5m | 4m x 4m | 4m dia.
1. Add the 16 marble weight plates
to the steel Cantilever base before
setting up Cantilever Umbrella.
OR
Secure steel base plate to
concrete slab using dyno bolts.
Ensure concrete slab or timber deck meets
requirements and surface is safe to mount to.
2. Secure the frame to cantilever
base with bolts and Allen key.
3. Using a step ladder place roof
fabric over the Cantilever frame.
5. Secure Velcro around the frame
awning pole.
4. Ensure the centre of the fabric is
aligned with the center of the frame.
6. Attach canopy to main frame
with qty
1
bolt & washer. Attach the
fabric to the ribs with qty
7
screws &
washers.
8. Slide the main connector up the
frame until pin locks into place.
7. Unfasten the screw until loose.
8. When crank becomes tight stop.
9. Fasten srew until tight.
7. Using the crank wind the
umbrella open.
OPTIONAL WEIGHT PLATE
OPTIONAL STEEL BASE PLATE
SET-UP
INSTRUCTIONS
Please read instructions completely before setting up your umbrella. Make sure you
have all the components identified on the parts list. Recommended procedure below.
For safety reasons it is recommended that 2 persons set-up / pack down any umbrella.