EX410A-en-GB_V6.0 6/16
7
AC VOLTAGE MEASUREMENTS
WARNING:
Risk of Electrocution. The probe tips may not be long enough to contact the live parts
inside some 240V outlets for appliances because the contacts are recessed deep in the outlets. As
a result, the reading may show 0 volts when the outlet actually has voltage on it. Make sure the
probe tips are touching the metal contacts inside the outlet before assuming that no voltage is
present.
CAUTION:
Do not measure AC voltages if a motor on the circuit is being switched ON or OFF.
Large voltage surges may occur that can damage the meter.
1. Set the function switch to the highest V AC ( ) position.
2. Insert the black test lead banana plug into the negative
COM
jack.
Insert red test lead banana plug into the positive
V
jack.
3. Touch the black test probe tip to the neutral side of the circuit.
Touch the red test probe tip to the hot side of the circuit.
4. Read the voltage in the display. Reset the function switch to successively
lower V AC positions to obtain a higher resolution reading.
DC CURRENT MEASUREMENTS
CAUTION:
Do not make current measurements on the 10A scale for longer than 30 seconds.
Exceeding 30 seconds may cause damage to the meter and/or the test leads.
1. Insert the black test lead banana plug into the negative
COM
jack.
2. For current measurements up to 200µA DC, set the function switch to the
200µA DC (
) position and insert the red test lead banana plug into the
uA/mA
jack.
3. For current measurements up to 200mA DC, set the function switch to the
200mA DC position and insert the red test lead banana plug into the
uA/(mA
jack.
4. For current measurements up to 10A DC, set the function switch to the
10A DC range and insert the red test lead banana plug into the
10A
jack.
5. Remove power from the circuit under test, then open up the circuit at the
point where you wish to measure current.
6. Touch the black test probe tip to the negative side of the circuit.
Touch the red test probe tip to the positive side of the circuit.
7. Apply power to the circuit.
8. Read the current in the display.
www.
.com
1.800.561.8187
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30