D I A M A N T
Pro
11
SERVICE PROGRAMMING: GENERAL
Restore factory settings
In order to restore default settings, follow the steps below.
1.
Turn the machine off.
2.
Turn on machine, wait 1s until it says “ReV 1.XX” in the OLED display and press K1, K3, K5 until
the OLED shows “PRES”. Then stop pressing K1,K3, K5 until it says in the Touch display “Preset…
Done!”.
3.
After the main display shows “Preset… Done!” you can turn off machine and restart it normally.
Settings are back to default.
Pro Tip:
Only technicians should do the reset. The machine might not be properly set up after a reset
Check heating groups, and steam boiler temperature)
OLED display preset
TFT display preset
Machine version
Steam boiler
temp.
Nº heating
groups
SmartSteam
E-Cup heater
menu
Diamant Pro 2Gr
Single Boiler
118ºC
OFF
Enabled/Disabled
(Optional)
Enabled/Disabled
(Optional)
Diamant Pro 2Gr
Multiboiler
120ºC
2
Enabled/Disabled
(Optional)
Enabled/Disabled
(Optional)
Diamant Pro 3Gr
Single Boiler
118ºC
OFF
Enabled/Disabled
(Optional)
Enabled/Disabled
(Optional)
Diamant Pro 3Gr
Multiboiler
120ºC
2
Enabled/Disabled
(Optional)
Enabled/Disabled
(Optional)
The following parameters are set as default within the Technician Settings menu:
