28
Before switching the device off, it must be disarmed for safety reasons. This is done via radio control
once the transmitter is switched to test mode (by sending a disarming signal to all receivers) or via
returning the mode channel of your DMX controller to its 0 setting.
After disarming, the minus button of the X2 Wave Flamer can be pressed to completely remove all
pressure from the system.
Once the pressure has been released, the device can be switched off by use of the main switch.
9 MANUAL CONTROL VIA R ADIO
The X2 Wave Flamer features a predefined set of sequences (see
attachment 1 - List of
sequences
), which allow for direct use of several sequences via box and channel numbers.
A detailed guide on how to send manual ignition signals can be found in the manual of the X2-series.
9.1 PREPARING THE MANUAL IGNITION MODE
In order for the X2 Wave Flamer to be able to receive igniion signals via radio control, the DMX mode
must be deactivated. After switching teh DMX mode off, a restart of the system is neccessary.
Further, in the GroupBOX menu you can check if the group box numbers needed for the show have
been assigned:
In manual ignition mode, the Wave Flamer will accept any
ignition command on its assigned Group box number.
Menü
Edit DMX settings
M-DMX: Modus
OFF
Menü
Edit Wave Flamer settings
M-Set: GroupBOX