Overview
EX9486-L features four serial ports, 10/100 Mbps Ethernet, USB port and SD
socket for flash disk expansion. The pre-install Linux OS and GNU tool chain
make EX9486-L ready for your application development.
Packing List
EX9486-L is shipped with following items
1. EX9486-L
2. TopSCCC CD includes Tool Chain, Installation guide and example programs
EX9486-L Panel Layout
Connector Description
Power Connector
Connect the 9 to 48VDC power line to EX9486-L. If the power is properly
supply, the power LED will show a solid green color.
Ethernet Port
The Ethernet Port use RJ45 connector
10/100Mbps Ethernet
USB2.0 Host x2
Reset
9-48VDC Power
P1/P2/P3/P4
Serial Ports
Serial Port
The four serial ports use RJ45 connector and the pin assignment are shown
as following table.
USB Port
The USB 2.0 Host port now supports following devices
1. USB
Storage
Device
2.
USB to Wireless LAN Adaptor (Ralink RT2570)
3.
USB to Ethernet Adaptor (Realtek RTL8150)
4.
USB to Serial Adaptor (Prolific 2303)
Use command
modprobe
rt2570
and
modprobe rtl8150
load the device
driver. USB to Serial Adaptor (ttyUSB0 and ttyUSB1) are built-in Kernel.
SD Socket
The SD socket is compatible with SD memory card specification version
1.0. The SD Socket is located in the back panel of the PCB. To install the
SD memory card, please use the screw driver to open the metal case of
EX9486-L and unscrew Screw 1 to 4 as following
1 2 3 4
DIP ON
EX9486-L Quick Installation Guide
DIP Switch
Power LED
System Ready LED
Ethernet LED
Serial Port LED
DIP Switch
Switch is a four keys DIP switch and Key 1 and 2 are used to configure the
hardware interface mode of serial port P1 and Key3 and Key 4 are reserved for
your application.
Reset Button
Press the “Reset” button to activate the hardware reset. You should only use
this function if the software does not function properly.
Power LED
The Power LED will show solid green if power is properly applied
Ready LED
The Ready LED will show solid green if EX9486-L complete system boot up.
If Ready LED is off during system boot up, please check if power input is
correct. Turn off the power and restart EX9486-L again. If Ready LED is still
off, please contact the manufacture for technical support.
Link/Act
When Ethernet port are connected to the network, Link/Act will show solid
green and if there is traffic is the Ethernet, this LED will flash
Serial Port LED
These four dual color LEDs indicate the data traffic at the serial ports. When
RXD line is high then Green light is ON and when TXD line is high, Yellow
light is ON.
SD Socket
Screw 1
Screw 2
Screw 3
Screw 4
