59
SunSDR2 DX User Manual
© 2020 Expert Electronics
ExpertSDR2 SOFTWARE DESCRIPTION
5.7.1.3
TX
In this tab, you can adjust the TX filter separately for different modes.
SSB/DI G L/DI G U/AM/DSB - settings for the low or/and high TX filter fronts.
·
Low – low front filter's frequency.
·
High – high front filter's frequency.
·
Of f set – frequency offset. Used for work in digital modes. Frequency offset requirement
depends on the used digital mode program. Look at the instruction of your digital mode
program.
·
Sync wit h RX – set this checkbox to make TX filter bandwidth equal to RX filter bandwidth.
Note:
·
Limits of the TX filter bandwidth in SSB mode: low - from 10 Hz up to 10000 Hz, high - from
60 Hz up to 18000 Hz.
Tone – settings for the dual-tone signal.
·
Enable – enable the dual-tone transmission mode.
·
Frequency 1/2 – set the independent frequency for the Tone 1 and Tone 2 signals
respectively.
·
Tone 2 – enable the Tone 2 signal.
NFM - Narrow band receiver FM settings.
Summary of Contents for SunSDR2 DX
Page 2: ......
