7
5.
MACHINE INSTALLATION
The place where the machine will be placed is under the sole responsibility of those who install and use this
equipment. It is therefore necessary to remember that the machine must not endanger people who pass
through or work nearby. All risks arising from normal work procedures as well as from extraordinary ones
that may occur, must be assessed.
The purifier should preferably be installed in a sheltered place, on feet or supports (not supplied) on the floor
or on walls or ceilings using non supplied suitable support systems.
It is also recommended to respect the following points:
do not turn the machine on its side
if the machine cannot be placed on the floor, create a raised supporting surface for the purifier
if the machine is placed outdoors it is necessary to set up a canopy and walls that protect it from
rain, the electrical panel must always be placed in a dry place.
Any elements needed for installation (supports, canopies, etc.) are not included in the supply and those
using this machine must set them up at the site.
For installation, proceed as follows:
position the machine in the established place
connect pipes or accessories required for fumes intake
connect electrical panel to electrical supply network
adjust any shutters on the air intake pipe
5.1
MECHANICAL CONNECTION
Verify that the installation space can contain the equipment and that there is enough space for safe
installation.
Identify the inlet and outlet of the different sections.
IN
OUT
IN
OUT
Filtering section
Ventilation section