1. Start engine and drive the machine forward and
backward for a few minutes to allow any extra air to
purge out of the hydraulic system.
2. Stop engine and wait for all moving parts to stop.
Remove key and engage parking brake.
3. Check expansion tank and if necessary add Exmark
Premium Hydro oil to the FULL COLD line.
Note:
The proper amount of oil should have been
added at the factory. If the reservoir is slightly over
full, Do Not remove fluid. The level will go down
once all of the air is purged from the system.
Figure 2
1.
Engine
2.
Expansion tank
4. Replace expansion tank cap and tighten until snug.
Do Not overtighten.
Filling Out the Product
Registration
Fill out the online warranty registration form and place
keys into literature pack.
3
