XET-20
800.533.3948 • www.barronltg.com
10070201 Rev 1 - 03/18
1
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
•
CAUTION
- This unit operates in conjunction with more than one power supply output source. To reduce the risk of
electrical shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit.
•
CAUTION
- This is a sealed unit with no servicable parts. Replace the entire unit when necessary.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
•
DO NOT USE OUTDOORS
. For use with grounded, UL listed fixtures. Not for use in heated air outlets or hazardous
locations.
• Requires and unswitched A.C. power source of either 120 or 277 volts, 50/60Hz.
• Compatible with lighting fixture loads on a 20 amp maximum circuit.
• Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibilty before final
installations.
SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS