Installing and Connecting the XTA-50
16
XTA-50 User Guide
2.2
Connecting the XTA-50 to a Power Source
Subject
The XTA-50 is dedicated to be connected to a SELV circuit.
The XTA-50 has a chassis connected to ground via the power supply cord. A protective
ground connection by way of the grounding conductor in the power cord is essential for
safe operation.
You must use the power adapter provided with the XTA-50. For voltage specifications,
see section
Technical Specifications, p. 9
.
Before Starting
Procedure
1.
Make sure the power adapter is not plugged to the wall socket.
2.
On the rear panel (see
), make sure the power switch is set to
O
.
3.
On the rear panel, connect the power cord of the adapter to the 12 V connector.
4.
Connect one end of the provided power supply cord to the power adapter located on
the rear panel and plug the other end to the proper voltage wall socket outlet (to
know the voltage requirement, see section
Technical Specifications, p. 9
).
5.
On the rear panel, set the power switch to
I
.
Warning
•
Make sure the wall socket on which the XTA-50 will be plugged is
protected by a 16 A max circuit breaker.
•
Make sure the XTA-50 power source does not apply more than 265 Volts
RMS between the supply conductors and the ground.
•
To avoid the possibility of injury, make sure the socket outlet in which the
power supply cord will be plugged is equipped with a protective ground
contact, and that the electrical installation fulfills the local safety
requirements.
•
The XTA-50 system is intended to operate from an external power
adapter 12V/8A. Use the one provided by EXFO at instrument delivery or
contact EXFO for replacement unit.
Summary of Contents for XTM-50 O-band
