EXFO T200S, User Manual, Page: 84 / 146

SCPI Command Reference
78
T200S
General Commands
*STB?
Description
The *STB? query returns the contents of the Status Byte register,
as defined in Status Byte Register (STB) on page 47.
Type Overlapping, query only.
Syntax *STB?
Parameter(s) None.
Response Syntax <register value>
Response(s) register value:
The <register value> value represents the bit values of the Status
Byte Register.
The <register value> ranges from 0 through 255.
See the content of this register in
Status Byte Register (STB) on
page 47.
Example(s)
*STB? returns 68 (the MSS and EAV bits are set)
See Also *SRE? on page 77
*TRG
Description This command causes the immediate exit from the event detector
of a trigger sequence if the system is waiting for the BUS event
source. Otherwise, the command is ignored.
This command generates a trigger event that starts the sweep or
the sweep sequence (depending on the parameters), if the
system is waiting for the BUS event source.
Applicability This command only applies if the command
TRIGger[:SEQuence]:SOURce on page 133 or
ARM[:SEQuence][:LAYer]:SOURce on page 81 is set to BUS.
Syntax *TRG
Parameter(s) None.
Example(s)
*TRG
See Also ARM[:SEQuence][:LAYer]:SOURce on page 81
INITiate[:IMMediate][:ALL] on page 89
TRIGger[:SEQuence]:SOURce on page 133