EXFO T200S, User Manual, Page: 28 / 146

Setting Up Your T200S
22
T200S
Renaming the Instrument
3. Select the tab corresponding to your IP address type: IPv4 or IPv6
4. To manually set the connection parameters:
4a. Clear the Obtain an IP address automatically check box.
4b.
Set the IPv4 or IPv6 (depending on your network configuration) address , subnet
mask or prefix length and default gateway to identify your T200S.
5. To automatically retrieve the connection parameters (IP address, subnet mask and
default gateway) from the connected network (DHCP), select the
Obtain an IP(v6)
address automatically
check box.
The connection is automatically established. You cannot modify the connection values.
6.
Touch Apply to validate the set connection parameters.
7. If you want to retrieve the previously applied connection parameters, touch the Refresh
button.
8. Touch the button to exit the Settings window.
Renaming the Instrument
The default instrument name is "T200-<serial number>". The following procedure explains
how to change the instrument name.
To change the instrument name:
1.
In the T200S task bar, touch the button to display the Settings window and select
the
Ethernet
tab.
The Name area enables you to rename the T200S.
2.
Touch the Rename button.
3.
Modify the instrument name (15 characters maximum) and touch Rename .
The instrument name will be modified at next startup.
4.
Touch the button to exit the Settings window.