EXFO T100S-HP Essential, User Manual, Page: 22 / 70

Installing and Connecting the Product
22 T100S-HP User Guide
2.2 Connecting the T100S-HP to a Power Source
Before Starting
Procedure 1. Make sure the power adapter is not plugged to the wall socket.
2. Make sure the power switch is set to 0 .
3. Connect one end of the power supply cable to the rear panel of the product and plug
the other end to the proper voltage mains supply point. The T100S-HP is equipped
with a self-regulating power supply that adapts to both AC 110V and 230V voltages,
and 50 Hz or 60 Hz frequencies.
2.3 Connecting External Optical Devices to the product
Subject You can connect external optical components and instruments to the T100S-HP.
Before Starting
Warning
• Make sure the product power source does not apply more than 265 Volts
RMS between the supply conductors or between either of the supply
conductors and the ground.
• To avoid the possibility of injury, make sure the socket outlet in which the
power supply cord will be plugged is equipped with a protective ground
contact, and that the electrical installation fulfills the local safety
requirements.
• The T100S-HP has a chassis connected to ground via the power supply
cable. A protective ground connection by way of the grounding conductor
in the power cord is essential for safe operation.
Caution
Keeping fiber-optic connectors clean at all times is essential to achieve
optimum system performance. Refer to the cleaning instructions in section
Cleaning and Caring for Optical Connectors and Fibers, p. 55 . The standard
output connector is a FC/APC connector. Never connect another type of
connector to the optical output.
Warning
• The use of optical instruments with this product will increase eye hazard.
Do not under any circumstances look directly into the fiber end of an
optical cable attached to the optical output while the device is in use for
this may cause permanent eye damage and possible loss of eyesight.
Note that the laser radiation is not visible to the human eye, therefore,
protective cap must always be replaced on the laser output connector
after use to avoid involuntary exposure to laser radiation.
• Disable the laser output before connecting or disconnecting a fiber optic
cable on the product.