EXFO Power Blazer 88200NGE, User Manual

Page: 493 / 887

Test Results
Power Blazer
483
FTFL/PT and PT

Operator Identifier displays the received operator identifier (bytes 1
to 9 for forward, byte 129 to 137 for backward).

Operator Specific displays the received operator specific (bytes 10 to
127 for forward, byte 138 to 255 for backward).
PT (Payload Type)

Payload Type
and
Code
Received displays the received payload signal type and its code in
hexadecimal format.
Expected allows selecting the expected payload signal type either by
selecting the payload from the list or by typing its hexadecimal code.
Note:
Refer to PT / Global PT on page 219 for the list.

OPU-PLM
1
, when selected, enables the OPU-PLM alarm analysis.

Copy RX/Global Copy RX
2
uses the received payload type as the
expected payload type. For Multi-Channel OTN lower ODU layer, use
the arrow button next to the
Copy RX or Global Copy RX to switch
from one button to the other;
Global Copy RX
uses the current
channel received payload type as the expected payload type for all
channels while
Copy RX
only affects the selected channel.
1. For Multi-Channel OTN lower ODU layer, the OPU-PLM check box is only configurable from the test setup.
2. Only available for Multi-Channel OTN lower ODU layer.