EXFO Power Blazer 88200NGE, User Manual

Page: 362 / 887

Test Setup - Test Configurator, Timer, and System
352
88000 Series
Streams - Global

Addressing MAC/IP indicates the source and destination MAC/IP
addresses for each stream. Tap on the
Addressing MAC/IP
button to
modify the customer addressing (see MAC and IP from the
MAC/IP/UDP
tab). When using
Provider Encapsulation
, the source
and destination addresses displayed are respectively EoE MAC for EoE
and B-MAC for PBB-TE.
Batch button allows bulk configuration for stream addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From
Apply To , select all streams the copy
applies to and tap on the
Copy From
to proceed.
The following parameters are global for all streams.

Total TX Rate
indicates the percentage of the total line utilization
which is the TX rate sum of all enabled streams.

Link Capacity
indicates the total rate available for traffic generation.

Global Options :

Rate Unit
choices are
%
(default),
Mbit/s
,
Gbit/s
,
frame/s
, and
IFG
.

QoS Metrics Tags Insertion check box when selected (default)
automatically adds a stream analysis tag containing Jitter, Latency,
Throughput, and sequence tags in all frames that is generated.

Copy Stream
button allows copying the stream configuration to one or
several streams.
Select the stream number the configuration will be copied from.
From To the following Streams , select all streams that will inherit the
configuration from the selected stream. An orange background
represents a selected stream. A stream that is already enabled (Enable
TX) cannot be selected for copy.
Tap Copy to confirm the stream configuration for all selected streams.

Restore Default
button reverts the current test application to its default
factory settings.