EXFO Power Blazer 88200NGE, User Manual

Page: 323 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
313
S-OAM and MPLS-TP OAM

Requesting MEP ID TLV (G.8113.1) check box when selected (default)
determines if the Requesting MEP ID TLV is present in the LBM frame.
The
Requesting MEP ID TLV check box is cleared and not selectable
when the
Continuous
check box is selected.

Priority , available with S-OAM Mode or when VLAN is enabled (see
VLAN
on page 268), allows selecting the VLAN user priority:
0
(default)
to 7 . Refer to VLAN ID and Priority on page 842 for more information.

Drop Eligible
, available with S-OAM Mode or when VLAN is enabled
(see VLAN on page 268), when set to Yes (DEI = 1), the transmitted
frames will be dropped first on receipt when congestion occurs under
test. Drop Eligible is only configurable with
Unicast address type,
otherwise is set to
No
(Default). Drop Eligible is set to
No
for
Frame
Delay , Frame Loss , and Synthetic Loss functions.

Period
determines the transmission period of frames which is set to
100 ms . Period is not applicable for Multicast address type or when the
Continuous
check box is selected.

TX Rate (%) is the transmission rate of the LBM frame: 0.0001 to 95 %
for 10M,
99.5 %
for 100M,
99.95 %
for 1G,
99.995 %
for 10G LAN, and
92.8521 % for 10G WAN. Only available with Loopback test function
when the
Continuous
check box is selected.