EXFO Power Blazer 88200NGE, User Manual

Page: 248 / 887

Test Setup - Test Configurator, Timer, and System
238
88000 Series
Labels
Labels
For SONET/SDH BERT: From the
Test
menu, tap
Setup
,
Test Configurator
,
the interface block, and on the Labels tab.
For OTN-SONET/SDH BERT: From the
Test
menu, tap
Setup
,
Test
Configurator , the protocol block, and on the Labels tab.
Note:
Selecting a Label byte to be generated will automatically update the
corresponding OH byte. Refer to
OH - SONET/SDH on page 666 for more
information.
Labels

STS/AU Path (C2)
: The C2 byte is allocated to indicate the content of
the STS SPE / VC, including the status of the mapped payloads.
Generated
: Select the C2 byte from the list. Selecting a C2 byte value
will automatically update the OH C2 selection and vice versa. Refer to
C2
on page 674 for more information.

PLM-P/UNEQ-P / HP-PLM/HP-UNEQ : Enables the Payload Mismatch
and STS/AU UNEQ monitoring. This setting is coupled with the
configuration of
Traces (SONET/SDH) on page 597.
Expected
: Select the expected C2 byte from the list. Refer to
C2
on
page 674 for more information.