EXFO Power Blazer 88200NGE, User Manual

Page: 244 / 887

Test Setup - Test Configurator, Timer, and System
234
88000 Series
Interface

Min RX Power (dBm) indicates, when supported, the minimum
received power level of the optical laser/lane in dBm.

Max RX Power (dBm) indicates, when supported, the maximum
received power level of the optical laser/lane in dBm.

Laser ON/OFF button, available with parallel interfaces, is used to
activate the laser control per optical lane or for all lanes.
Optical lane numbers are from 0 to 3 or 0 to 7 depending on the
selected interface/rate.

All Lanes check box, when selected, applies the change(s) to all
optical lanes at once.

Optical Lane indicates the optical lane numbers and All which
represents the setting for all optical lanes when the
All Lanes
check box is selected.

Laser
check box, when selected, indicates that the corresponding
optical laser lane is activated and emitting an optical laser signal.

Laser OFF at Start-Up
check box when selected, cleared by default,
automatically turns OFF the laser for serial interfaces or all lasers for
parallel interfaces when starting the module or when switching from
one test application to another; this applies on both ports for
Dual Port
topology. However the laser remains ON, on a remote module
receiving a request for a DTS connection or a loopback command.