EXFO Power Blazer 88200NGE, User Manual

Page: 224 / 887

Test Setup - Test Configurator, Timer, and System
214
88000 Series
Frequency
Frequency
Note: The Frequency tab is only available for parallel interfaces.
From the
Test
menu, tap
Setup
,
Test Configurator
, tap on the interface
block, and on the Frequency tab.
Port, FlexO Instance ID, and FlexE PHY Number
Note:
Only available with FlexE/FlexO BERT test application.

Port
allows selecting the physical port to be displayed.

FlexO Instance ID indicates the FlexO instance identifier assigned to
the port.

FlexE PHY Number indicates the FlexE PHY number assigned to the
port.
TX Frequency

TX Frequency (GHz)
indicates the frequency (actual fre
Frequency offset) used for transmission.
Note:
Frequency offset is not available with Multi-Channel OTN and FlexE/FlexO
BERT.

Offset (ppm)
check box, when selected (cleared by default), allows
setting the frequency offset that will be generated. Use the “+” or “-”
button to respectively increment or decrement the frequency offset
value based on the defined
Increment/Decrement Size , or directly
type the frequency offset value in the field. The range is ±120 ppm for
Ethernet test applications, ±50 ppm for Transport Framed, and
±120 ppm for Transport Unframed test applications.