EXFO Power Blazer 88200NGE, User Manual

Page: 201 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
191
EtherSAM - Burst
EtherSAM - Burst
Note: The Burst settings are only available for configuration when the Burst Test
check box is selected (see page 193).
From the Test menu, tap Setup , Test Configurator , tap on the test block,
and on the
Burst
tab.
Note: The burst configuration parameters are defined globally for all services but
CBS , EBS , and Burst Max Rate parameters are as per each service
configuration.
Burst Sequence
The graphic illustrates the configured burst sequence that contains in
order, from left to right:

Refill Delay represents the pre-burst recuperation time in percentage
that is equal to the remaining percentage not used by the post-burt
time (
Refill Delay Ratio ).

Burst Frames
represents the burst frame ratio in percentage that is
equal to the substraction of 100 % - Burst/IR Frame Ratio .

Refill Delay
represents the post-burst recuperation time in percentage
that is equal to the configured Refill Delay Ratio .

CIR or CIR+EIR Frames
represents the percentage of transmission at
CIR or CIR+EIR rate. The CIR or CIR+EIR Frames percentage is equal
to the configured
Burst/IR Frame Ratio
.

The “. . .” next to the burst sequence indicates that the burst sequence
is repeated the number of times specified in the
Number of Burst
Sequence field.