EXFO Power Blazer 88200NGE, User Manual

Page: 195 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
185
EtherBERT, FC BERT, BERT (eCPRI, CPRI/OBSAI, and FlexE), and Unframed BERT

Pattern Sync icon indicates the status of the received signal pattern.
Refer to
Status Bar
on page 32 for more information. Not available with
EtherBERT.
Bit/Pattern Error
The configuration of Bit Error is available with all patterns at the exception
of
Seed A
and
Seed B
for which
Pattern Error
is available.

Pass/Fail Verdict enables and sets the bit/pattern error rate/count
threshold prior to run the test. This allows for a simple pass/fail verdict,
leaving no room for misinterpretation of the test results. To enable the
pass/fail verdict, select either
Bit
/
Pattern Error Count
or
Bit / Pattern Error Rate (default is Disabled ).

BER Threshold
allows entering the threshold
Count
or
Rate
value that
will be used to declare the pass/fail verdict.
For
Count
, enter the maximum bit/pattern error count allowed before
declaring a fail verdict: 0 (default) to 999999 .
For
Rate
, enter the maximum bit/pattern error rate allowed before
declaring a fail verdict: 1.0E-14 to 1.9E-01 . The default value is 1.0E-12 .
CPRI/OBSAI
Note:
Available with CPRI/OBSAI BERT test application with Framed L2.
Pass/Fail Verdict
check box when selected (default) enables the pass/fail
verdict. A pass verdict is given when the link status is up and no
CPRI/OBSAI alarm and/or error are recorded for the duration of the test.