EXFO Power Blazer 88000 Series, User Manual

Page: 499 / 803

Test Results
Power Blazer
487
Summary (EtherSAM)
Committed

Frame Loss Rate
indicates the rate of frames that are lost. The
reported value is the maximum rate of Frame Loss from all burst
sequences and ramp steps excluding the
CIR+EIR
,
EBS
, and
Traffic Policing steps. Frame Loss is displayed as a percentage
value when the remote module does not support exponential
notation.

Max. Jitter (ms)
indicates the maximum measured delay
variation.

Max Latency (ms)
indicates the maximum measured round-trip
latency (delay). For Dual Test Set the local to remote and remote to
local values are reported for One-Way Latency Measurement Mode
while a single round-trip value is reported for Round-Trip Latency
Measurement Mode (see
Global Options
on page 168).

Avg RX Rate , for Service Performance Test , indicates the
measured average utilization throughput.
Excess
Max RX Rate
, for
Service Configuration Test
, indicates the
measured maximum utilization throughput.

VLAN Preservation
indicates if any VLAN mismatch occurred during
any step of a Ramp or Burst tests as follows:
Grey: Undefined
Green: No Mismatch detected
Red: Mismatch detected