EXFO Power Blazer 88000 Series, User Manual

Page: 282 / 803

Test Setup - Test Configurator, Timer, and System
270
88000 Series
S-OAM and MPLS-TP OAM
Next HOP Router (G.8113.1)

MAC Address , available when Resolve MAC check box is cleared,
allows entering the Next HOP Router MAC address: 00:00:00:00:00:00 to
FF:FF:FF:FF:FF:FF, default is 01:00:5E:90:00:00. The MAC Address
01:00:5E:90:00:00 is reserved for point-to-point link and can be used
when the unicast address is unknown (as per RFC-7213).

Resolve MAC
check box, when selected (cleared by default), sends a
request to the network to retrieve the MAC address corresponding to
the selected IP address.

IP Address , available when Resolve MAC check box is selected,
allows entering the Next HOP Router IP address: 0.0.0.0 to
255.255.255.255 for IPv4; default is the source IP address; ::1 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for IPv6, default is 2001::.
Local Parameters

MEG ID
(Y.1731 and G.8113.1), the Maintenance Entity Group Level
identification, allows defining a 13-bytes MEG ID value/message to be
generated (default value is
EXFO MEG ID
). Values should be ASCII
suitable characters including the ITU T.50 Characters on page 40.
Padding
allows the selection of the character (
Null
or
Space
) to used
for remaining byte values.

MAID
(802.1ag and MEF) is a 45 bytes Maintenance Association
Identification that is divided into two parameters:

Domain ID
is an optional domain identification text field
(0 byte (Domain ID not present), up to 44 bytes minus the
MA Name
field length) set to
EXFO Domain ID
by default.

MA Name (Short MA Name) is a Maintenance Association Name
text field set to
EXFO MA Name
by default. The length of the M
A
Name field is from 1 to either 44 bytes minus the Domain ID field
length when Domain ID is present or 45 bytes when not present.