EXFO Power Blazer 88000 Series, User Manual

Page: 222 / 803

Test Setup - Test Configurator, Timer, and System
210
88000 Series
MAC/IP/UDP
MAC

Source MAC Address indicates the default and unique Media Access
Control (MAC) address given to the Ethernet port; editable when using
Provider Encapsulation .

Destination MAC Address
: Enter the destination MAC address for the
stream. The default setting is the source MAC address. The destination
MAC Address field is not accessible when the
Resolve MAC Address
check box is selected.

Resolve MAC Address
check box, when selected (default), sends a
request to the network to retrieve the MAC address corresponding to
the selected destination IP address. This setting is coupled with the
Resolve MAC Address check box from IP on page 213. This check box
is not available when the
Network Layer
is set to
None
(refer to
Modify
Frame Structure on page 205).

OAM Quick Ping
button automatically starts the quick Ping utility for
the stream destination MAC address and provides either a successful
or failed result. The quick Ping uses 3 attempts, a delay of 1 second,
and a Timeout of 5 seconds.

EtherType
is set to the following values by default and is configurable
from 0x0000 to 0xFFFF when the Network Layer is set to None :
0x0000
when
Network Layer
is set to
None
0x0800 for IPv4
0x86DD
for IPv6
0x8847 for MPLS
0x88B7
when
Network Layer
is set to
None
with EtherBERT test.
0x8902 for S-OAM (available with EtherSAM)

OUI
, available when the frame format
802.3 SNAP
is selected, allows
the selection of the Organizationally Unique Identifier (OUI):
RFC1042
(0x000000) - (default)
User Defined , available when Network Layer is set to None , allows
entering the
OUI
value:
0x000000
(default) to
0xFFFFFF
.