EXFO Power Blazer 88000 Series, User Manual

Page: 216 / 803

Test Setup - Test Configurator, Timer, and System
204
88000 Series
MAC/IP/UDP
MAC/IP/UDP
Note: Only available with Framed Layer 2 (see Framing from the Modify Frame
Structure
).
From the Test menu, tap Setup , Test Configurator , and...

For
RFC 2544
and
EtherBERT
, tap on the protocol block.

For EtherSAM , and Traffic Gen & Mon , tap on the protocol block, and
on the
MAC/IP/UDP
tab. For Traffic Gen & Mon all parameters are
configurable per stream. For EtherSAM all parameters are configured
per service.
Stream Selection (Traffic Gen & Mon)
The Traffic Gen & Mon test application supports the configuration of up to
16 different streams. Select the stream to be configured by either using the
left/right arrow or by tapping over the stream numbers area then tapping
on a specific stream number.
Service Selection (EtherSAM)
The EtherSAM test application supports the configuration of up to 10
different services. Select the service to be configured by either using the
left/right arrow or by tapping over the service numbers area then tapping
on a specific service number.
Couple with Interface
The
Frame Format
,
Network Layer
, and all
IP
and
VLAN
settings are
coupled with the interface (see Network on page 220) when the Couple
with Interface
check box is selected (default). The
Source MAC Address
is always coupled. Not available when using Provider Encapsulation .