System Tabs
372
IQS-8500 Series and IQS-8120NGE/8130NGE
Default/Ethernet Test Preferences
Interface Configuration
Note:
The following IPv4 configuration parameters apply to both the stream and
the interface and are available for both ports
(IQS-8510B)
. The
configuration of
Stream Tag in TX
applies as well to IPv6.
Auto-Negotiation
: The Auto-Negotiation check box should be
selected if the connected switch is also set to Auto-Negotiation,
otherwise the Auto-Negotiation check box should be cleared.
When selected, the Ethernet and Fibre Channel Application will
indicate to the switch which parameters to use. The
Auto-Negotiation
check box is selected by default. Available with
10/100/1000Mbps interfaces.
Stream Tag in TX
allows to automatically select the
Stream Tag
check box (refer to page 204) every time a
Frame Analyzer
test is
created. The
Stream Tag in TX
check box is selected by default.
IP Address
: Enter the IP address for both the stream and the
Ethernet port. The factory IP address is
10.10.x.y
, where
x
and
y
are respectively the two least significant bytes of the port default
MAC address.
Automatic IP Address
: Automatically selects DHCP when a test is
created allowing to dynamically obtain an IP address from a DHCP
server. The
Automatic IP Address
check box is cleared by default.
Subnet Mask
: Enter the subnet mask for both the stream and the
Ethernet port. The default setting is
255.255.0.0
.
Default Gateway
: Enter the default getaway address for both the
stream and the Ethernet port. Default Gateway must be enabled to
enable the default gateway address field. The default setting is
0.0.0.0
.
Enable
: Enables the default gateway IP address for both the
stream and the Ethernet port. The
Enable
check box is not
selected by default.
