EXFO IQS-8120NGE, User Manual

Page: 128 / 546

Creating and Starting a Test Case
114
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet TCP Throughput Test Case
2. Port configuration:
Port 1
(IQS-8510B only) is automatically selected.
2a.
Select the port Connector
Type (Optical
or
Electrical RJ-45 ). Optical is automatically selected for the
Ethernet 10G
interface.
2b. For Electrical RJ-45, if required, select
the
Ethernet port crossover
check box
to inverse the pin-to-pair assignment of
the UTP cable used.
Note: At this point you should have a link up indicated in the Tree view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the
Ethernet port
crossover setting is correct.
2c.
Press Next .
3. Framing configuration:
3a. Set the Auto-Negotiation , Speed ,
Duplex
, and
Flow Control
parameters.
Refer to Interface Setup (Ethernet) on
page 142 for more information.
3b. Select the Frame Format . Choices are
Ethernet II
and
802.3 SNAP
. Refer to
Network on page 150 for more
information.
3c.
Set the IP Address (IPv4), Automatic IP
address
,
Subnet Mask
, and
Default
Gateway parameters. Refer to Source IP Configuration on
page 152 for more information.
3d. Press Finish to complete the test setup. The Alarm summary tab
is automatically displayed.