EXFO FTB-860, User Manual

Page: 178 / 409

Trace Route Test Setup and Results
166
FTB-860/880
Global Configuration
IP

Source IP Address : Displays the Source IP Address configured in the
Network
page. To modify the
Source IP Address,
press
IP Config
. For
more details, see Source IP Configuration Pop-Up on page 309.
Note:
For IPv6, instead of Source IP Address , configure Source Link Local IPv6
Address and Source Global IPv6 Address .

Destination IP Address
: Enter the
Destination IP address
of the
network device to be detected.
The default setting for IPv4 is
10.10.0.0
or is set automatically to the IP
address of the target module from the Remote Loopback mode. The
destination IP address is configured only when
Ethernet/IPv4/UDP
is
selected. The accepted range for IPv4 is 0.0.0.0 to 255.255.255.255 .
The default value is
0.0.0.0
.
The default setting for IPv6 is
2001:0000:0000:0000:0000:0000:0000:0000
or is set automatically to
the IP address of the target module from the Remote Loopback mode.
The destination IP address is configured only when
Ethernet/IPv6/UDP
is selected. The IPv6 Address can either be the Link-Local IPv6
Address
or the
Global IPv6 Address
. The acceptable range for IPv6 is
from 000:0000:0000:0000:0000:0000:0000:0001 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
.
Procedure

Timeout (ms) : Enter the maximum time allowed between an ICMP
echo and response at each hop. Choices are
200 ms
to
10000 ms
. The
default setting is 4000 ms .

Max Hop Count
: Enter the maximum network device the packet is
allowed to go through. Choices are 1 to 255 . The default setting is 128 .