EXFO FTB-860, User Manual

Page: 154 / 409

Through Mode Test Setup and Results
142
FTB-860/880
Configure a Through Mode Test
Configure a Through Mode Test
To configure a Through Mode Test:
1.
From the
Test
menu, press
Setup
.
2. From the Test Applications tab, under Ethernet group, press Through
Mode
.
Note:
If the interface type is 10Gbit/s a message is displayed to change the
interface to 10/100/1000Mbit/s Electrical.
3.
From the Interface tab, configure the Port , Network settings, and view
the information on the SFP/SFP+ page. See Interface on page 280.
Ensure that the link is up in the status bar before proceeding to the next
step.
4.
Press Start to start the test. Summary result page will be automatically
displayed. See Summary Results on page 143.
5.
For additional results, refer to Traffic - Statistics Results on page 145,
Traffic - Flow Control Results on page 147, Alarms/Errors -
Ethernet/Fibre Channel on page 329, WIS Traces/Label on page 343.
6. If required, press the Report button from the side panel to generate the
report file of the results and statistics. For more details, See Report
Button on page 262.