EXFO FTB-860, User Manual

Page: 113 / 409

EtherBERT Test Setup and Results
NetBlazer
101
Configuring a EtherBERT Test
Configuring a EtherBERT Test
To configure the EtherBERT test:
1.
From the
Test
menu, press
Setup
.
2.
From the Test Applications tab, under Ethernet group, press
EtherBERT
.
3. From the Interface tab, configure the Port , Network settings, and view
the information on the SFP/SFP+ page. See Interface on page 280.
Ensure that the link is up in the status bar before proceeding to the next
step
4. Optionally, set a remote module in loopback. See Discover Remote
Button on page 251.
5. Press the Global tab. Configure the global settings by referring to
Global Configuration on page 102.
6. Press the MAC/IP/UDP tab, and configure the stream settings by
referring to MAC/IP/UDP Configuration on page 302.
7. Press Start to start the test. Summary result page will be automatically
displayed. See Summary Results on page 106.
8. For additional results, refer to Alarms/Errors - Ethernet/Fibre Channel
on page 329, WIS Traces/Label on page 343, and Logger on page 347.
9. If required, press the Report button from the side panel to generate the
report file of the results and statistics. For more details, See Test Control
on page 243.