EXFO FTB-1, User Manual

Page: 559 / 675

Test Control
NetBlazer
547
Report Button
Report Button
The report contains all information about the current test including its
setup and results.
Note:
Nothing prevents the configuration and alarm/error injection setup while
the test has been stopped; thus, the report should be saved/printed before
changing any test parameters to avoid printing discrepancy between the
configuration and results.
The
Report
button is available when the test is running or stopped, but the
report generation is only possible when the test is stopped. It is possible to
save, open, import, export, and delete test report(s).
Config/Save Tab
The
Config/Save
tab allows to configure the report parameters and
generate/save the report.
Tap the
Report
button and the
Config/Save
tab.

Job Information parameters are used to identify the source of the
report and are not mandatory. Enter the following job information if
required:
Job ID , Contractor Name , Customer Name , Operator
Name
,
Circuit ID
, and
Comment
. Up to 30 characters are allowed for
each parameter at the exception of Comment for which 256 characters
are allowed.
Restore Default reverts all Job Information parameters back to the
default values.