EXFO FTB-1, User Manual

Page: 241 / 675

Test Setup - Test Configurator, Timer, and System
NetBlazer
229
S-OAM and MPLS-TP OAM
Note:
Sending traffic with frame size >1518 in switched network may result in
losing all frames.

Frame Count
is the quantity of frames to be transmitted:
1
to
1000
at
the exception of Frame Loss function which is 2 to 1000 (default
is
10
); set to
1
for Loopback function with Multicast address type; not
applicable when the Continuous check box is selected at the
exception of
Synthetic Loss
function.

TLV Type defines the TLV Type included in the frame: Data (Default),
Test
(
Loopback
(
Y.1731
and
G.8113.1
) and
Test
functions), and
Test
ID ( Frame Delay function); is set to Test for the Test function; set to
Data
for
Synthetic Loss
function; not available for
Frame Loss
function.

Payload
, available with
Data
TLV Type, defines the repeating byte
pattern used to fill the payload of the Data TLV: 0x00 to 0xFF (default is
0xCC
).

Test Pattern , available with Test TLV Type, defines the test pattern used
to fill the
Test
TLV:
PRBS31
(default),
NULL
.

Test ID , available with Test ID TLV or Synthetic Loss function, defines
the test ID:
0x00000000
to
0xFFFFFFFF
(default is
0x00000001
).
Restore Carrier Ethernet OAM Defaults
Reverts the Carrier Ethernet OAM test application to its default factory
settings.
Label 2 4 bytes G.8113.1
Continuous 18 bytes for Data TLV Type
21 bytes for Test TLV Type
Requesting MEP ID TLV 56 bytes
Parameter Number of bytes to be added Apply to