EXFO FIP-500, User Manual

Page: 29 / 131

Getting Started with Your Unit
Fiber Inspection Scope
19
Configuring Your Unit at First Startup
Configuring Your Unit at First Startup
The first time you turn on the unit, you are prompted to read and accept
the EXFO license agreement and configure the date and time.
Note:
You can change the regional parameters later if necessary.
Once the configuration is complete, you are presented with a QR code
allowing you to download the user documentation to a smart device.
Note:
Depending on the type of smart device you are using, the appearance of the
EXFO Exchange application may vary slightly from the illustrations
presented in this documentation. Unless otherwise specified, the
information applies both to the Android- and iOS-based smart devices.
Note:
Both on your unit and in the EXFO Exchange application, the period is used
as the decimal separator in numerical values, when applicable.
Note:
On your unit, the period is used as the decimal separator in numerical
values, when applicable.
To configure your unit at first startup:
1.
If it is not already done, turn on the unit (see Turning on Your Unit on
page 17).
2.
Read and accept the EXFO license agreement as follows:
2a. Use the QR code to download the license agreement to your
smart device.
2b. Select the
I agree with the terms of this license agreement
box,
then tap Next .
3. If necessary, configure the date and time (tap the line corresponding to
the item you want to modify). When it is done, tap
Next .