Copper, VDSL2, ADSL2+, and IP Triple-Play Test Set
221
15 Running a VoIP Test
The purpose of the VoIP analysis test function is to allow you to configure
the unit for VoIP testing. During the analysis, the unit determines the DSL
and IP packet rate, and calculates jitter, packet loss, and packet delay.
Results are displayed on the following tabs.
To view the available tabs:
Press the left/right function arrows on each side of the F1, F2, and F3 keys.
Reading Results
Summary
The
Summary
tab allows you to view the
PASS/FAIL
status and
Details
of
the different tests. If a measured value is out the thresholds configured in
the VoIP analysis setup, or if the WAN/LAN connection was not completed
successfully, the
Summary
pane will display a
FAIL
message.
The available test results are the
following:
³
Line Status
displays either
Connected
or
Disconnected
for
the particular line connection
under test.
³
WAN Status
displays whether the
unit is
Connected
to the wide area
network, or in idle mode.
³
LAN Status
displays if the unit is
Connected
to the local area network.
³
Network Activity
displays whether or not voice protocol registration
activity is detected.
³
Call History
specifies the signaling protocol being used and
determines the state of the call along with the call flow.
³
Pcks Analysis
displays the status of the percentage of packets of
varying inter-arrival rates that are within 10 milliseconds of each other.
