Copper, VDSL2, ADSL2+, and IP Triple-Play Test Set
205
14 Data Analysis
The purpose of the Data Analysis test function is to have the unit act as a
DSL modem allowing you to connect from your computer to the internet
via the unit’s Ethernet port. The unit will display the connected DSLAM
parameters as well as bandwidth utilization, statistics for the IP traffic, and
the different protocols detected as you send and receive information.
To view the available tabs:
Press the left/right function arrows on each side of the F1, F2, and F3 keys.
Reading Results
Test Summary
The
Test Summary
tab allows you to view the
PASS/FAIL
status and
Details
of the different tests. If a measured value is out the thresholds
configured in the data analysis setup, or if the WAN/LAN connection was
not completed successfully, the
Test Summary
pane will display a
FAIL
message.
The available test results are the
following:
³
Line Status
displays either
Connected
or
Disconnected
for
the particular line connection
under test.
³
WAN Status
displays whether the
unit is
Connected
to the wide area
network, or in idle mode.
³
LAN Status
displays if the unit is
Connected
to the local area network.
³
IP Packets
provides a summary of the total amount of data received
(being addressed to) and sent by a specific device on the local
network.
