XL8000 Series
Door Closer Installation
Left hand fitting only, use reverse for right hand fitting.
Standard Door Installation (Pull Side) - Fig 1
Hinge knuckle
is visible
Door Frame
Door
2 - Latching Speed
Adjustment Valves
1 - Closing Speed
Door Closer Body
Armset Shoe
Frame Fix Installation (Push Side) - Fig 61
Hinge knuckle
is
not
visible
Door Frame
Door
Adjustment Valves
2 - Latching Speed
2 - Latching Speed
1 - Closing Speed
1 - Closing Speed
Door Closer Body
Armset Shoe
180 degree
door installation
120 degree
door installation
Step by Step Installation Guide
Use the appropriate template for your installation and place
the template on the door and frame. Pilot drill all fixing holes
as per the template.
1.
Position the door closer with the adjustment valves facing
the hinge side of the door. Secure the door closer using
the screws provided into the pre-drilled pilot positioning
holes.
2.
Attach the armset to the pivot on the door closer body and
secure using the washer screw.
3.
Tension the door closer arm and adjust the arm length
accordingly. Secure the arm set shoe to the door or frame
depending on installation, then tighten the arm set nut.
4.
Apply the dust cap to the unused pivot.
5.
Adjust the closing and latching speeds as required -
refer to adjustment instructions.
NB after the first month of operation the closing and latching
speed valves may require minor adjustment.
Standard Door Installation - View from above
Pull Side - Fig 1
Washer Screw
Dust Cap
Armset Pivot Screw
Hinge Knuckle
Adjustment Valves
Door Closer Body
Preload
Armset
Nut
Threaded
Arm (bolt)
Armset Shoe
Frame Fix Installation - View from below
Push Side - Fig 61
Hinge Knuckle
Adjustment Valves
Door Closer Body
Preload
Armset
Nut
Threaded
Arm (bolt)
Armset Shoe
Washer Screw
Armset Pivot Screw
Dust Cap
4 8 3 1 1 3
EN1154:1996 / A1:2002 / AC:2006
EN1634-1:2008 FD30/FD60 Timber Doors
*Fig 1 Application Only
30/60
C
180 degree
door installation
120 degree
door installation
CAUTION
Adjusting valves more than 2 full turns
anti-clockwise from factory settings will
result in oil leakage damaging the door closer.
Failure to comply with this will void the warranty.
Acceleration
Deceleration
Valve Adujustment Instruction Guide
Closing Speed:
Adjust valve by quarter turns
anti-clockwise to increase speed or clockwise to
reduce speed.
Latching Speed:
Adjust valve by quarter turns
anti-clockwise to increase speed or clockwise to
reduce speed.
